Long-line Sleeveless Jacket – Free sewing patterns

Essentials

Boiled wool fabric, 2.2m Fusible interfacing, 1mCoordinating thread

Sizes

Small, medium, large

Cutting guide

Front jacket: cut one pairBack jacket: cut one on foldCollar: cut one pair in main fabric, cut one in interfacingFront facing: cut one pair in fabric, cut one pair in interfacingBack facing: cut one on foldUse a 1.5cm seam allowance throughout, excluding the belt and belt carriers.

1 Download and print the templates. Cut out the pieces following the cutting guide. Fuse interfacing to the front facings and one of the collars. With the right sides of the two collars facing, stitch them together leaving the neck edge open. Trim away the bulk from the corners, then turn to the right side. Tease out the seams and corners and press.

2 Match, pin and stitch the shoulder seams of the front two jacket pieces to the back jacket with right sides facing. Press the seam allowances open. Align the centre of the collar on the neck edge and the centre back neck edge of the jacket back, matching the notches and dots and stitch to the neck of the jacket.

3 Pin and stitch the shoulder seams of the two front facing pieces to the back facing, with right sides facing. Press the seam allowances open. Position the joined facing over the attached collar, matching the notches and taking it down the centre front edges. The facing is shorter than the jacket to accommodate the 4cm hem. Stitch the facing in place around the neck and down the front, sandwiching the collar inside.

4 With the right sides of the facing and jacket still together, match the armholes and stitch in place. Clip around the curved seam allowance and turn the jacket to the right side by threading the front jacket parts through the shoulders. Tease out the seam allowance around the armholes, clip around the neckline, trim the bulk from the corners and turn the facing to the right side. Push out the corners and press.

5 Match the side seams together, pin and stitch from the dots indicated on the pattern at the top of the splits up to the underarm, then into the edges of the facings. Make sure the armhole seams are open when stitching this seam. Press the seam open and continue folding and pressing the edges of the splits. Fold the facing back inside under the arms and hand stitch in place to stop it from rolling out. Fold and press up a 4cm hem. Sew the corners of the splits and hand stitch the hem.

6 Cut two 3cm x 8cm strips of fabric for the belt carriers. Fold in half lengthways and stitch together with a 5mm seam allowance. Turn to the right side and fold in 1cm at each end. Stitch them in place at the points indicated on the pattern.

7 Trim a 12cm wide strip of fabric the width of the fabric. Fold and match the two long edges, pin and cut an angle into each end. Stitch the edges together with a 1cm seam allowance, leaving a gap in the centre of the belt. Trim the corners and turn to the right side. Tease out the seam allowance and press. Hand slip stitch the gap.